Whole-home heating and cooling through your existing ductwork
A forced-air heat pump replaces your furnace and central AC with a single system. Eligible for up to $10,000 in Energize CT rebates, with financing as low as ~$64/month.
Your estimate accounts for ductwork, insulation, and electrical needs
One system for heating and cooling. A forced-air heat pump replaces your furnace and central AC with a single unit that moves heat in both directions. If you are replacing an old furnace or upgrading from a less efficient system, we guide you toward models that make sense for your layout and lifestyle.
Cost depends on your setup. Most projects fall between $10,000 and $30,000 before rebates, with a typical mid-range install around $15,500. Ductwork condition, system capacity, home envelope and insulation, electrical panel compatibility, and installation access all factor into the total.
What you'll walk away with
Ductwork assessment and sealing if needed
Equipment selection matched to your home
Rebate paperwork filed on your behalf
Full performance check before handoff
How it works
One system for heating and cooling, sized and installed for your home
HOW IT WORKS
One electric system replaces your furnace and central AC
- Replaces both the furnace and central air conditioner with a single electric system
- Uses existing ductwork — every room currently heated and cooled stays on the same system
- Cold-climate models produce usable heat well below freezing
SYSTEM SELECTION
The right system depends on how your house is actually built
- Broad catalog: Daikin, Carrier, Trane, Goodman, and Mitsubishi
- Estimate covers ductwork, zone capacity, insulation, panel capacity, and access
- We walk you through the reasoning so the quote is clear, not a mystery number
What changes once your heat pump is running
The same unit that warms your rooms through a Connecticut winter cools them through the summer, so you run and maintain one system instead of juggling a separate furnace and central air conditioner.
An efficient heat pump matched to your home moves heat rather than burning fuel, so winter bills come down and stop swinging the way an aging furnace makes them swing.
Air moves through your existing ducts at a steady, controlled pace, so rooms hold an even temperature without the noisy cycling and cold corners of older equipment.
We work with brands you trust
As authorized dealers and installers, we carry top-rated HVAC and home comfort equipment from leading manufacturers.
5 steps to a new system you can count on
Every installation follows the same proven process — whatever equipment you're upgrading — from your first call through years of reliable service.
Step 1
In-Home Assessment
We visit your home, inspect the equipment you're replacing, and listen to what you want to change. You get a written, itemized estimate — no cost, no obligation.
- Home walkthrough
- Equipment inspection
- Written estimate
- Your current setup inspectedWe assess the equipment being replaced and how it connects to your home.
- Home measured for proper sizingSquare footage, layout, and insulation all factor into the right capacity.
- Comfort issues documentedTell us what bothers you — cold rooms, noise, running out of hot water — and we plan around it.
- Itemized estimate with equipment, labor, and applicable rebatesYou get a clear cost breakdown before making any decisions.
Step 2
Your Options
Based on the assessment, we present options that fit your home and budget — typically a good, better, and best choice — and explain the trade-offs in plain language.
- Multiple options
- Plain-language trade-offs
- No pressure
- Clear recommendation with pros, cons, and cost breakdownWe explain each option so you can make an informed decision.
- Efficiency ratings explained for each optionWe show what higher efficiency costs up front and saves over time.
- Right-sized to your homeProper sizing prevents short cycling, uneven performance, and wasted energy.
- Your questions answered before you commitTake the time you need — the estimate stands either way.
Step 3
Rebates & Financing
We check every rebate your new equipment qualifies for through Energize CT — heat pumps can earn up to $10,000 — and line up financing so you see the real monthly cost before you decide.
- Rebates identified
- Financing available
- 5-15 year terms
- Energize CT rebate eligibility confirmed for your equipmentWe check the current programs so nothing is left on the table.
- Financing terms from 5 to 15 years availableWe present multiple financing options to fit your budget.
- Complete cost plan with rebate offsets where applicableYour quote shows the full picture including all available savings.
- Monthly payment options calculatedWe break down what your monthly cost will be under each financing plan.
Step 4
Installation Day
Our licensed technicians remove the old equipment and install your new system to manufacturer specifications and local code. Most installations are finished in a single day.
- Licensed technicians
- Code-compliant
- Clean job site
- Old equipment removed and disposed of properlyWe handle all removal and disposal of your old system.
- New system installed to manufacturer specsEvery connection and component meets manufacturer requirements.
- Connections updated as neededElectrical, piping, venting, or ductwork adjusted to fit the new system.
- System tested and verified before we leaveWe run the full system and confirm proper operation before signing off.
Step 5
Walkthrough & Warranty
Before we go, we walk you through your new system — controls, settings, and what to expect. Then we register your manufacturer warranty and set up optional maintenance plans.
- Hands-on walkthrough
- Warranty registered
- Maintenance plans
- You see the system run and learn the controlsSettings, filters, and what normal operation looks like — you'll know how everything works.
- Manufacturer warranty registered and activatedWe handle all warranty paperwork so you are covered from day one.
- Follow-up checks scheduled as neededWe schedule return visits to verify everything is running properly.
- Optional maintenance plans for long-term performanceRegular tune-ups keep your system efficient and extend its lifespan.
Heat pump rebates can cover most of the cost
Federal tax credits and Energize CT rebates make heat pump installation significantly more affordable. Replacing electric baseboard or resistance heat? Your heat pump may qualify for an enhanced Energize CT rebate of $1,500 per ton (up to $10,000) — we confirm eligibility and handle the paperwork.
Energize CT heat pump rebates
Up to $10,000 eligible
As an Energize CT Authorized Contractor, HCP helps you access programs funded by a charge on customer energy bills. Your home energy audit copay is just $40.
- Up to $10,000 for qualifying heat pump installation
- Up to $900 for heat pump water heater
- Rebates based on system size and efficiency rating
Financing for heat pump projects
Low-rate financing
Multiple financing options help you start your heat pump project now without the full upfront cost.
- Smart-E Loan low fixed rates for energy improvements
- On-bill financing pay through your monthly utility bill
CT HIC License HIC #0644515 CT HTG License HTG #0303270-S1
Energize Connecticut — programs funded by a charge on customer energy bills.
Trusted by families for heat pump installations
Heating services
Whether you need installation, repair, or a full replacement, we handle every heating system.
Heating Installation
New furnace, boiler, or heat pump — installed with rebate support
Heating Replacement
Upgrade an aging system to modern efficiency
Heating Repair
Fast diagnosis and honest repair recommendations
Heating Maintenance
Bi-annual tune-ups to extend system life
System Comparison
Side-by-side comparison of heating options
Heating Rebates
Energize CT rebates up to $10,000 for heat pumps
Water Heaters
Heat pump water heaters and high-efficiency tank replacements.
Air Sealing
Seal gaps and cracks that let conditioned air escape and outdoor air in.
Still have questions?
Call us at (203) 450-3000 or request a free estimate.
Ready to see what a ducted heat pump would cost?
Free estimate. No pressure. Licensed CT contractor (HIC #0644515).